Updating is not supported by data source

Posted by / 01-Jul-2020 15:12

Updating is not supported by data source

For other brands of JTAG debug probes, follow the instructions of its manufacturer.

When using multiple debug probes in the same host, it is necessary to set different serial numbers and enable its usage on the Debug Probe firmware.

XDS200 is the newest class of JTAG debuggers for Texas Instruments' microcontrollers and embedded processors.

It offers a balance of low cost with good performance between the super low cost XDS100 and high performance XDS560 classes of JTAG debuggers and is compatible with Code Composer Studio™ development environment version 5.2.0 and newer.

Close any instances of CCS that are running in your system.

Open a Windows Command Prompt and issue the following commands: \ccsv6\ccs_base\emulation\specdig\xds2xx for details of your model and version.

The SHORT form is typically an abbreviation, e.g., "PST", "PDT".

ICU derives its tz data from the IANA Time Zone Database.

The ICU project publishes updated timezone resource data in response to IANA updates, and these can be used to patch existing ICU installations.

In general they work well in Windows, therefore proceed with the update at your own risk as the JTAG debugger may be bricked and only recoverable by returning the board for repair.

To update a XDS200-class JTAG debugger connected via USB, using a Windows host is highly recommended.

updating is not supported by data source-17updating is not supported by data source-83updating is not supported by data source-79

Also, The XDS200 standalone JTAG debug probe can be purchased from the TI store.

One thought on “updating is not supported by data source”